Aseko ASIN AQUA Salt, Руководство пользователя

Страница: 28 / 48

EN 28
First start procedure
The water in the pool must be clean without any additives.
Ideally fi ll the pool with fresh water from the water main.
1. Ensure the fi ltration system runs NONSTOP for 24
hours
•
Set the required values via the main screen by pressing the appropriate tab
(see the chapter Control):
•
If you have the CLF probe, set the disinfection to 0.0 mg/l.
If you have the REDOX probe, set the disinfection to 000 mV.
•
pH value set to 7.4.
•
Set ALGICID to 10 ml m
3
per day (see the chapter ALGICID Setting) or set
FLOC+C to 10 ml m
3
per day (see the chaper FLOC+C Setting).
2. Close the water supply to the probes
ASIN AQUA Salt display “No water supply to the probes” notifi cation.
3. Perform superchlorination
Perform superchlorination of pool water with Super CHLOR (inorganic active
chlorine without stabilizers).
Follow the instructions on the packaging (1 kg = 80 m
3
).
24 Wait at least 1 hour. Optimally up to 24 hours.
Before opening the water supply to the probes, the water must be Before opening the water supply Before opening the water supply clean
and the chlorine concentration measured by the colorimeter or Pool Tester
must be within the range 0.3 to 1.2 mg/l.
If the concentration is lower , repeat superchlorination. If the concentration
is higher , wait till the chlorine concentration in the water drop down.
4. Open the water supply to the probes
the “No water supply to the probes” notifi cation will disappear from the ASIN
AQUA Salt display.
5. pH adjustment
• Set the required pH value ideally close to the pH value of the incoming
water.
• ASIN AQUA Salt adjusts the pH automatically according to the pre-
set required value.
• The ideal pH value should be between 7.3 and 7.6 .
6. Depending on the type of a probe you have, proceed
according to the chapter:
• If you have the CLF probe
•
If you have the REDOX probe
SuperCHLOR