TD 92639GB
2009-12-08/ Ver. C
Configuration Manual
Ascom d62 DECT Handset
13
4.7.3
Handset replacement with IMS2, Scenario 2
1
Make a note of the IPDI of the new handset. It is found by pressing *#06# on the
handset.
2
Insert the new handset into a desktop charger or rack charger connected to the
IMS2 and navigate to the Numbers tab in the Device Manager in IMS2.
3
Select the old handset in the list and make a right-click. Click "Associate with
device...". Select the device with an IPDI that matches your new handset from the
list that appears.
The new handset is automatically sýnchronized and all data and parameter settings
will be transferred to the new handset.
The synchronization will take a while if the Contacts in the original handset
contains a large number of contacts.
4
Subscribe the new handset.
4.8
Replacement of the handset with the PDM Windows Version
To see which data that is replaced during this process, see
4.7.1
Data included in a
replacement transfer
on page 12.
Both the old handset and the new handset must be of the same device type (d62 or d41).
The same extension number is assigned to the new handset.
The new handset should not be subscribed towards the PBX yet.
1
Perform a factory reset, see
4.5
Perform a Factory reset
on page 11, if the new
handset has been previously used.
2
Make sure that the old handset is saved in the PDM by starting PDM and navigating
to the Numbers tab. There shall be a tick in the "Saved" column for the old
handset.
If the handset is not saved, insert it into a desktop charger or rack charger connected to
the PDM and perform a save.
Note:
If it would be impossible to save the old handset settings, stop this replacement
procedure. Instead register the new handset and follow the instructions for installing a
handset, see
3.2
Installation of a new handset
on page 5.
The following steps are described in two different scenarios, check which one suits the
best before proceeding.
4.8.1
Handset replacement with Win-PDM, Scenario 1
Subscribe the new handset with the same extension number as the old handset. During
the subscription procedure the PDM identity (User ID) will automatically be set to be the
same as the extension number.
Note:
The User ID can be viewed by navigating to the menu Admin menu > Device info >
User ID.
1
Insert the new handset into a desktop charger or rack charger connected to the
PDM.
