TD 92333GB
2007-02-07/ Ver. D
User Manual
9d24 Mkll Cordless Telephone
22
when the Mute key is released. The dial-code is set in the Soft/Hot key as a “Phone
number”. To set the “Phone number” see chapter
Note:
When this function is enabled all calls started with a Soft key or Hot key will be
using the push-to-talk function.
The second push-to-talk function is used in DECT systems that are connected to systems
where only one person is allowed to speak at the same time. The handset sends DTMF
tones to the connected system when the Mute button is pressed/released to open/close
the speech channel.
5
Alarm Operation
Note:
9d24 Mkll Protector only.
5.1
Push-button Alarm
Press the red alarm button twice within two seconds to activate the alarm. An
information text is displayed, default “Personal Alarm” is displayed. The alarm is sent to
the alarm central that distributes it further. After that the handset returns to stand-by
mode. Note that you can always trigger the alarm when you are speaking, editing your
settings, or while the phone is locked.
5.2
Test Alarm
Press and hold the red alarm button until the information text is displayed, default “Test
Alarm” is displayed.
5.3
No-movement Alarm
Note:
The stand-by time will decrease by approximately 25% when the handset is
equipped with the Alarm Module.
You can activate/deactivate the alarm function in the menu, see
on page 39, or by programming a Soft/Hot key as a shortcut to the
function, see
on page 39. To activate/deactivate in the handset
require a a SIM card parameter setting. The Soft/Hot key changes the state of the alarm,
i.e. if it is deactivated it will be activated and vice verse. Press the Soft key, or press and
hold the Hot key, to put the alarm in operation respectively out of operation. The “No-
movement alarm on” icon on your display is an indication that the No-movement alarm is
in operation.
Send no-movement alarm
The No-movement alarm will go off when you have not moved within a preset time
(default 30 seconds). Before the alarm is activated a warning signal sounds and the “No-
movement on” icon starts to flash. If you do not cancel the alarm by pressing a key, it is
sent and “No-movement/man-down Alarm” is shown in the display.
