Operating Instructions Ascoline 850, MGH 2xx, 4xx, 6xx
ascobloc
Gastro-Gerätebau GmbH
01156 Dresden, Grüner Weg 29
Germany
Tel.: +49 351 4533-0
Fax: +49 351 4533 433
E-mail:
,
MGH2XX.doc, Edition: 20.03.2008
Subject to change without notice!
11
Imaging 4:
Switch panel MGH 615
Imaging 5:
Electric oven (without bottom and plug-in register)
9 Conversion to other types of gas
The appliance can be converted to use other types of gas. The conversion must be performed by an
authorised installing company and carried out in compliance with locally applicable regulations. To do
this, the appliance is to be completely disconnected from all electrical supplies and close the gas supply
valve in the customer's extent of supply.
The technical possibilities are listed in the "Nozzle Sets" table. Material can be ordered according to the
table from Customer Service or dealers. The use of nozzles other than those authorised for the
gas/supply correction pressure leads to destruction of the appliance and to health hazards for the
personnel (CO emission).
The gas adjustments carried out in the factory are given on the gas type plate. Subsequent conversions
to other gas types or supply pressures must be entered permanently and legibly on the gas type plate of
the appliance. Such labels are enclosed with replacement nozzle sets. Only use special nozzles obtained
from Customer Service or dealers!
9.1 Changing nozzles
The main and small adjustable nozzles of the cooking zone burners and of the small adjustable nozzles
in the gas-fired oven are accessible once the valve cover of the all-gas valve has been removed. First,
pull off all control knobs. Do this by inserting a flat-blade screwdriver behind the knob and at the same
