Ascendo SV-12, Руководство пользователя

Страница: 11 / 12

11
WARRANTY
Your Ascendo SV-12 Powered Subwoofer is covered by a limited warranty against defects in
materials and workmanship for a period of 5 years on the cabinet and woofers, and 1 year on the
amplifier from the original date of purchase.
This warranty is provided by the authorized Ascendo dealer where the subwoofer was purchased.
Warranty repair will be performed only when your purchase receipt is presented as proof of ownership
and date of purchase. Defective parts will be repaired or replaced without charge by your dealer’s store
or by Ascendo authorized locations to service Ascendo products. Charges for unauthorized service and
transportation cost are not reimbursable under this warranty. This warranty becomes void if the product
has been damaged by alteration, misuse or neglect. Ascendo assumes no liability for property damage
or any other incidental or consequential damage whatsoever which may result from the failure of this
product. Any and all warranties of merchantability and fitness implied by law are limited to the duration
of this express warranty. Some states do not allow limitations on how long an implied warranty lasts,
so the above limitations may not apply to you. Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation or exclusion may not apply to you.
TROUBLESHOOTING
SITUATION PROBABLE CAUSE SOLUTION
No sound from
subwoofer(s)
Amplifier is not connected to
constant power outlet Make certain the amplifier is
plugged into an unswitched AC
power outlet
Amplifier is not receiving an
audio signal from receiver or
processor Make certain there is an audio
signal from receiver or processor
and audio connections resemble
those in the connections section
of this manual
Amplifier fuse might be blown Replace fuse (if fuse is not
readily accessible, consult your
authorized dealer)
Performance is less
than expected
The + and - polarity of the
subwoofer wire might be
reversed on the subwoofer Check the entire system for
proper polarity and experiment
with the phase switch
Crossover frequency not
adjusted correctly Adjust crossover frequency by
turning the crossover frequency
control clockwise until desired
sound is obtained
L/R line level input is
connected instead of the
LFE line level input If bass management is enabled
on receiver or processor make
sure to use the LFE line level
input (see amplifier controls and
setup on the previous page)