3
Caution
Do not hold near flame or use in an unstable location.
This may result in fire, injury or deformation.
When vacuum packing, do not vacuum liquid without attaching the liquid
catch canister.
if liquid leaks from the bottom of the unit, its surroundings get wet.
Do not put fingers on the PTFT strip.
Closing the seal bar may pinch or burn fingers.
Use the unit only when the bag is placed in position.
This can cause overheating or fire.
Use the appliance only for its intended use.
Improper use may cause electric shock, short or fire.
Do not allow the unit to vacuum flammable liquid or gas.
Fire may result.
Quality of vacuum packing is not guaranteed.
Conditions such as packaged food shelf life and vacuum method may cause
food degradation or rot.
Grasp plug to remove the cord from the receptacle outlet.
Failure to do so may result in cord damage, electric shock, short or fire.
Do not use an unstable outlet or a damaged cord or plug.
Do not place heavy objects on the power cord, apply excessive force, deform
or bundle it.
Damaging the power cord may cause electric shock or fire.
Do not touch hot surfaces , which may cause burn.
Unplug the appliance from the outlet when not in use.
A burn, electric shock, short or circuit fire may result.
Care
Before operating the appliance unplug the power cord from the outlet.
Replacement of the PTFT Strip
Replace the PTFT strip when it is damaged and comes off.
Remove the old PTFT strip and install a
new one.
Warning
- For surfaces where the PTFT strip becomes
soiled with oil or dust, clean the surface and
replace the strip.
- Be careful not to wrinkle the strip.
- Position the strip so that it covers the
electrodes.
Replacement of Heating Wire
Replace the heating wire when the sealing weakens or the wire is broken.
After removing the PTFT strip, unscrew
the heating wire from the electrodes and
install a new one.
Warning
-Setscrews are placed on both sides of the
strip.
-Replace PTFT strip under the heating wire.
-Place the strip under the heating wire to make
sure that the heating wire does not touch the
unit.
Tips
The heating wire is fixed by the electrodes.
As shown in the right illustration, adjusting
the electrodes inward with a flat head
screwdriver makes replacement easier
when installing.
Adjust the terminals inward
with a flat head screwdriver.
14
PTFT strip
Heating wire
