Asada ROLL GROOVER 640, Инструкция по эксплуатации

Страница: 5 / 20

ROLL GROOVER 640
5
◆ Hold a material certainly using a Grooving Shaft and a pipe stand.
◆ If a material is 60cm or longer, be sure to use a pipe stand.
◆ Do not leave the machine with a long material set on it. You may tumble over
it and get hurt.
◆ Securely install accessories in accordance with this manual. Otherwise,
accident or injury may happen.
◆ Use the Grooving Roller and Grooving Shaft proper to a material size. As
applicable material sizes are written on Grooving Roller and Grooving Shaft,
please change them according to the material size.
◆ Materials should be attached properly. Set the material 0.5 degrees aslant against
the machine. Make sure that the machine and material are parallel to the ground.
◆ Make sure that the material is not deformed or the surface of the material is
not inclined. It may cause of a defective groove.
◆ Turn the handle at according to the following indicated speed.
◆ If handle is turned fast, the material may get deformed and cause of a
damage to the machine.
◆ Base Bracket that matches to the Threading Machine must be used.
◆ Otherwise, it will not allow proper processing and may cause a damage to
the machine.
◆ Make sure to check the dimensions after the operation.
◆ Make sure to polish the surface of the material by Sander and the surface of
the seal after the operation. Chamfering the pipe is required as well as they
may cause a leakage or a damage to the gasket.
◆ Check the machine carefully whether or not it has a damage before using and
make sure that it will operate properly and perform its intended function.
◆ If you have dropped or hit the machine accidentally, carefully check for
damage, crack or deformation. If the machine is damaged, it will work with a
poor accuracy and cause an accident and injury.
◆ Before leaving the machine for a long time, disconnect Power Plug.
◆ Keep your workbench and area in order and well-lighted.
◆ When the machine is not in use, it should be stored in dry and high or locked-
up place which children cannot reach out.
CAUTION
Handle rotation speed per 1 rotation of the material as follows
Schedule 10 steel pipe 1″～ 6″ 1/2 per rotation
Schedule 40 steel pipe
1″～ 4″ 1/4 per rotation
5″～ 6″ 1/8 per rotation