AVstream Owner’s Manual V1.2 © 2007 CE ARX Systems®
AVstream Owner’s Manual V1.2 © 2007 CE ARX Systems®
7
Complete online documentation is available on the ARX website:
www.arx.com.au/AVstream.htm
Specific queries can be emailed to the factory at
2
This symbol indicates that a Slow Blow fuse is used in this equipment.
Replace with same type and value only
This symbol is intended to alert you to the presence of uninsulated
dangerous voltage within the product's enclosure that may be of sufficient
magnitude to constitute a risk of electric shock.
This symbol is intended to alert you to the presence of important operating
instructions contained in this owner's manual
WARNING SYMBOLS USED ON THIS EQUIPMENT
IMPORTANT
- PLEASE READ THIS FIRST
This is a dual voltage unit. It is essential that you check that the voltage on the
fuseholder cover below the AC connector on the rear of the chassis is set correctly
before connecting it to AC power.
To change, pull fuseholder out and rotate 180
o
, then push in again. Do not insert
power cable into unit until voltage has been correctly set. Do not plug power cable into
AC power until voltage has been correctly set
THIS IS SET FOR 100 V
AC TO 120 V AC
OPERATION
THIS IS SET FOR 220 V
AC TO 240 V AC
OPERATION
Complies with 89/336/EEC EMC Directive,
amended by 92/31/EEC and 93/68/EEC and
meets the following standards:EN 55013 : 1990,
Sections 3.2 and 3.5 EN 55020 : 1988, Sections
4.3, 5.4, 6.2, 7.0, 8.0.
Complies with Australian Standard AS/N25 1053
AVstream
™
Specifications
Input Impedance
Mic
4 KOhms balanced
Line
100 KOhms unbalanced
Input Gain
Mic
Variable 20 dB to 60 dB with rear trim control
Line
–10 to +10 dB
Output Level (Max)
+ 21dB
Signal to Noise ratio
@ Unity
-90 dB ‘A’ weighted Note: All inputs @ unity, Master @ unity
Distortion
@ Unity Gain
Below .005% 100Hz to 10 KHZ
Dynamic Range
115 dB
Mic Channel EQ
Low
100Hz
15dBCut/Boost
High
10KHz
15dBCut/Boost
Zone EQ
Loudness Control
(Out) Flat
(In) 50z and 10KHz up to max +6dB
Level Control
oo to +6dB Gain (0 to 11)
Hi Z Input Connectors
Phono (RCA type)
Video Type
Composite Video
Video Input Connectors
RCA type
Balanced Output Connectors
Male XLR: Pin 1 Ground, Pin 2 +, Pin 3 –
Video Output Connectors
RCA type
Frequency Response
20Hz—20KHz ±1dB
Power Requirements
100-120/220-240 V AC 50/60 Hz 8VA (8 watts)
on 3 pin IEC connector
Weight
5 lbs/2.2 Kg
Dimensions
19"W x 1¾"H x 6"D, 482 x 44 x 155mm
Our policy is one of continuous improvement, and therefore designs may change
without notice. However, unless otherwise stated, specifications will always equal or
exceed those previously given. ARX® is a Registered Trade Mark of ARX Systems Pty
Ltd. AVstream™ is a trade mark or ARX Systems Pty Ltd. Any other names and
trademarks are used for information purposes only, and no other intent is expressed
or implied