Configuring Analyzer Nodes
Connect ETH1 port to a computer only for configuration purposes. It is running a DHCP server and should not be
connected to any other networks.
1. IPMI LAN Port
2. Power Supply (2)
3. ETH1: Config Port
4. ETH0: Mgmt Port
Figure 5
IntroSpect Analyzer 2XXX Series – Back View
3
1
4
1
2
Use the following steps to configure Analyzer:
1. Power up Analyzer by first powering on the lower-left node (as seen from the front) and then the other 3
nodes.
2. Connect laptop or computer to ETH1: Config Port. This is the ETH1 port on the Analyzer Node, the bottom
right node as seen from the back. This is also shown in
above.
3. Open a browser instance and connect to:
https://192.168.1.254:8443
.
4. Complete the IntroSpect setup wizard.
For detailed setup instructions, see the IntroSpect Appliance Setup Guides.
4
IntroSpect Analyzer 2XXX Series | Quick Start Guide