8
Aruba AP-375ATEX Series Access Points
| Installation Guide
Electrical
Ethernet
One 10/100/1000Base-T auto-sensing Ethernet RJ-45 Interfaces
Power over Ethernet (IEEE 802.3at compliant)
Environmental
Operating
Temperature: -40ºC to 65ºC (-40ºF to 149ºF)
Storage
Temperature: -40ºC to 70ºC (-40ºF to 158ºF)
Humidity: 5% to 93% non-condensing
For additional specifications on this product, please refer to the data sheet at
www.arubanetworks.com
.
Regulatory Model Number
The following regulatory model number applies to the AP-375ATEX:
AP-375ATEX: APEX0375
Safety and Regulatory Compliance
ATEX Marking
EN standard: EN 60079-0: 2018 and EN 60079-7: 2015 + A1:2018
WARNING – DO NOT OPEN WHEN AN EXPLOSIVE ATMOSPHERE IS PRESENT
WARNING – DO NOT CONNECT OR DISCONNECT WHEN ENERGIZED
WARNING – POTENTIAL ELECTROSTATIC CHARGING HAZARD – SEE BELOW
1. Control of environmental humidity to minimize the generation of static electricity;
2. Protection from direct airflow;
3. The equipment is not intended to be used when the area is known to be hazardous;
4. Gas detection monitoring;
5. Touch with an insulating object;
6. Means to continuously drain off electrostatic charges
.
Special Conditions of Use
The equipment incorporates non-metallic parts for the enclosure. These components should only be
contacted with a damp cloth as per the warnings on the equipment and in the manual to prevent the
possibility of an ignition through static discharge.
The enclosure for the equipment is not intended to be opened in normal operation. Follow the instruction
manual for repairing and maintenance for the equipment. The gaskets should be replaced if the enclosure is
opened for service.
APEX0375 series provided for the access to the input signal reference circuit ground (MOV & TVS). Care shall
be taken whilst installing the equipment to ensure a dielectric isolation of 500Vrms is maintained.
FCC
To view the FCC ID for controller-managed access points:
1. Log into the controller WebUI
2. Navigate to Maintenance > Controller > About
To view the FCC ID for Instant access points:
