Aruba 303H Series Hospitality Access Points
| Installation Guide
5
Figure 5
Gigabit Ethernet Port Pin-Out
USB Interface
The 303H Series access point is equipped with a
USB port that is compatible with cellular modems and
Bluetooth Low Energy (BLE) dongles. When active, the USB port can supply up to 5W/1A
to a connected device.
Figure 6
303H Series Side View
Push Button
The push button located on the right side of the device can be used to reset the access point to factory default
settings or turn off/on the LED display.
To reset the access point to factory default settings:
1. Power off the access point.
2. Press and hold the push button using a small, narrow object, such as a paperclip.
3. Power-on the access point without releasing the push button. The system status LED will flash within 5
seconds.
4. Release the push button.
The system status LED will flash again within 15 seconds indicating that the reset is completed. The access
point will now continue to boot with the factory default settings.
To turn off/on the LED display:
During the normal operation of the access point, press and release the push button using a small, narrow
object, such as a paperclip.
Power
The 303H Series access point supports up to 48V DC when using an AP-AC-48V36C power adapter (sold
separately). The power connector port is located on the side of the device, as shown in
.
The PoE-in (PoE-PD) allows the E0/PT port to draw power from an 802.3at (preferred) source, or an 802.3af
(optional) source.
When powered by an 802.3at or DC power source, the PoE-out (PoE-PSE) functionality is enabled on port E3,
supplying a maximum output of 15.4W to the wired device.
Refer to
Table 4
for power output details. PoE-PSE and USB settings can be enabled/disabled through the
software’s WebUI and CLI.
Before You Begin
Refer to the sections below before beginning the installation process.
48V
600mA
DC power socket
USB port
Reset button
Security screw lock
