ARTURIA – PROPHET V - MANUAL
89
Increase the resonance of the same filter (choose a value around 3.50). This will cause
the filter to resonate almost to the point of auto-oscillation.
Increase the resonance filter
In the “Poly Mod” module found to the left of the interface of the Prophet 5, modulate
the filter's cut off frequency through the frequency of oscillator B. To do this, click on the
button “FILT”. Increase the “OSC B” knob (to around .30) in order to set the level of this
modulation. The cut off frequency of the filter adjusts in a cyclical manner due to the
frequency of oscillator B.
Settings of the Poly Mod
You’ll notice that the oscillation frequency varies following the note played. This is due to the fact the frequency of
oscillator B follows the keyboard. The lower the note played the slower the oscillation (and inversely, the sharper the
note the faster the oscillation). If you do not wish to have this variation, deactivate the keyboard following by clicking
on the button “KBD”.
Deactivate the keyboard following
Apply a modulation to the square width of oscillator A through the LFO. To do this, click
on the PWA button found in the “WHEEL-MOD” section in the bottom left hand side of the
interface (just above the virtual keyboard).
Activate the PWA button
Choose a triangular wave-form on the LFO
Increase the virtual modulation wheel of the Prophet 5 to set the modulation rate (around
0.50).
