INSTALLATION STEPS
1. Check that all the installation pack contents have been received. There should be 3
items as shown below:
2. Determine location of towel warmer and install heating system pipework to proposed towel
warmer location. Tee off the main circuit to provide a branch circuit for the towel warmer.
Refer to page 3 for piping locations. The valve shown above is an angled valve which re-
quires piping through the wall. Straight valves are also available for piping coming through
the floor. Piping to towel warmer valves should be 1/2 ” copper. Note: Position towel
warmer so that at least two of the brackets are attached to a firm wall stud.
Brackets
Valve X 2
Hot water to
other appliances
Valve
Water Heater
Circulator Pump
Typical Heating System Diagram
