Lower Stand Assembly
Legs
Column Key Hole
Thank You…
for purchasing the Projector Floor Stand. This stand can accommodate all
Artograph projectors as well as many other types of projectors. It features a
large adjustable platform that will allow you to easily position and aim your
projector onto a wall, easel, or other vertical surfaces for convenient and
accurate projection. The platform may be rotated 360 degrees, tilted up to 15
degrees front to back, and elevated from 3 to 4 ½ feet high to meet just about
any projection need.
Please read over the following assembly instructions carefully, and if you
should have any questions or need help in anyway, please contact us toll-free
at 888-975-9555.
PARTS LIST:
Description
Part No.
1. Lower Stand Assembly ...........200-673
2. Upper Y-Bracket Assembly .....200-797
3. Tray (qty. 1) .............................200-796
4. Parts Bag (qty. 1) ...................200-768
a. Screw (qty. 2) ....................100-491
b. Locking Knob (qty. 2) ........100-678
c. Spacer (qty. 2) ..................151-779
d. Bubble Level (qty. 1) .........200-778
e. Column Key (qty. 1) ..........151-691
3
1
2
Figure 1
Remove all parts from the box and lay them out on
a table top or fl oor. For your convenience, the Lower
Stand Assembly and Upper Y-Bracket have been pre-
assembled. Hold the Lower Stand Assembly upright and
unfold the lower legs by pulling them and the sliding collar down
until the column key hole shows.
(Fig. 1). You may have to
loosen the leg-locking knob to free up the legs. (Knob located on
the sliding collar). Insert column key into the column key hole and
tighten the leg-locking knob to secure the legs in position. The
center column should fl oat about 4 inches above the fl oor. It should
not be fl at on the fl oor. To refold legs for storage, simply remove
the column key and loosen leg-locking knob.
1
LEG ASSEMBLY
Sliding Collar
