7
STEP 9:
Once the ARTP BBQ and the ARTP-SB2 Dual Side Burner gas been tested for leaks and all burner light up to
your satisfaction, it is time to close up the Side Burner Unit’s outside skin panels. (see figure #8)
Install the Back Cover (Item 2 - part # 100-3091 on page 2) by sliding the top section between the ARTP-SB2 pe-
rimeter and the inside support flange. The support flanges are shown on picture 6 on page 5.
Secure the back cover to the rear mounting bracket using (2) 10-32 x 1/2” pan head Philips screws (item 8 - part
200-0267 on page 2) as shown below at the bottom of the back cover.
Route the ARTP-SB2 power cord through the square cut-out hole in the back cover. Secure the cable with the
square strain relief (item 9 - part 210-0259 on page 2) by clamping the cable (close to the square cutout) and
pushing the strain relief into the square hole.
Install the side cover (item 1 - part 100-3090 on page 2) by sliding the top section between the ARTP-SB2 perim-
eter and the inside support flange. The support flanges are also shown on picture 6 on page 5.
Secure the side cover to the rear mounting bracket and front body using (2) 10-32 x 1/2” pan head Philips screws
(item 8 - part 200-0267 on page 2) as shown below at the bottom of the back cover.
Figure # 8
CABLE STRAIN
RELIEF
BACK COVER
POWER CORD
SIDE COVER
10-32 SCREWS
10-32
SCREWS
ROUTE
CABLE
