5
STEP 5:
Fasten the ARTP-SB2 Side Burner to the
ARTPC-SB2M Mounting Bracket with the
(2) 1/4-20 TRUSS head screws provided
in this kit. (item 4 - part 200-0057 on Page
2)
(See figure # 5)
The FRONT fastening point is located in-
side the body of the ARTP-SB2 ahead of
the igniter module or under the gas mani-
fold depending on which side (left or right
respectively) you are mounting the Side
Burner on the cart.
The REAR fastening point is located in the
Rear Mounting Bracket installed in step 3.
The ARTP-SB2 Dual Side Burner unit
should now be permanently attached to the
cart.
STEP 6: PIPING CONNECTION
With the pipe fittings provided in the kit, it is
now time to connect the gas line from your
ARTP BBQ to the Side Burner.
REMOVE the 3/8” ODF compression fitting
on the ARTP-SB2 pressure regulator and
REPLACE with one of the 3/8” COMP. x
1/2” NPT Compression Adapters provided.
Install the 3/8”Ø x 54” long flexible stainless
gas line in the fitting and tighten the com-
pression nut.
Route the flexible gas line into the body of
the cart by going through the rubber grom-
mets you installed in the previous steps in
the cart and rear bracket. The grommets are
required to protect the gas line from the
metal raw edges.
The pipe should be fed into the body of the
cart so it can be connected to the gas line
that the ARTP BBQ is connected to.
The gas line goes between the back of the BBQ firebox and the back of the cart, so the piping will drop and will
be visible inside the cart, under the BBQ. It is not required to remove the BBQ from the cart itself for this piping
procedure.
FRONT
FASTENING
POINT
Figure # 5
FRONT
FASTENING
POINT
(INSIDE BODY)
REAR
FASTENING
POINT
Figure # 6
REMOVE
3/8” ODF FITTING
REPLACE
WITH 3/8”x1/2” NPT
ADAPTER
NEW 3/8” Ø X 54” LONG
FLEXIBLE STAINLESS GAS LINE
GROMMETS ON BACK
BRACKET AND CART
BODY (2)
FLEXIBLE STAINLESS
GAS LINE TO CART
GAS
REGULATOR
SUPPORT FLANGES
SUPPORT
FLANGES
