Trademarks
Contents subject to revision without prior notice.
All other trademarks remain the property of their owners.
Copyright Statement
This publication may not be reproduced as a whole or in part, in
any way whatsoever unless prior consent has been obtained
from the owner.
FCC Warning
The converter has been tested and found to comply with the
limits for a Class A digital device, pursuant to Part 15 of the
FCC Rules. These standards are designed to provide
reasonable protection against harmful interference when this
device is operated in a commercial environment. This device
generates, uses, and can radiate radio frequency energy and
may cause harmful interference to radio communications
unless installed in accordance with this
User’s Guide.
Operation of this device in a residential area is likely to cause
harmful interference which will make the user responsible for
the appropriate remedial action at his / her own expense.
CE Mark Warning
These is a Class A product. In a domestic environment this
product may cause radio interference in which case the user
will need to consider adequate preventative methods.
1. Checklist
The package should contain the following items:
- Converter
- AC-DC Power Adapter
- User
’s Guide
Please notify your sales representative immediately if any item is
missing or damaged.
2. Overview
This converter is designed to meet the massive needs for Gigabit
network deployment and able to extend a copper based Gigabit
network via fiber cable to a maximum distance up to 80KM. It is
fully compliant with IEEE802.3, 802.3u, 802.3ab and 802.3z
standards. It can be installed into a Converter RACK. The
installation and operation procedures are simple and
straightforward. Operation status can be locally monitored
through a set of Diagnostic LED located in the front panel.
Major Features:
- Auto-Negotiation in TX port
- MDI/MDIX Auto-Crossover supported
- Support Flow Control
- Support Link Alarm
- Support Jumbo Frame 9K bytes (under 10,100,1000Mbps)
- Store and Forward Switching Mechanism
- Support Auto & Force mode configuration
3. Installation
- Attach fiber cable from the Converter to the fiber network.
The fiber connections must be matched
– transmit socket to
receive socket.
- Attach a UTP cable from the 10/100/1000BASE-T network
to the RJ-45 port on the Converter.
- Connect the power adapter to the Converter and check that
the Power LED lights up. The TX Link/Act and F/O Link/Act
LEDs will light up when all the cable connections are
satisfactory.
Figure 1. Front Panel of dual fiber model
Figure 2. Front Panel of WDM fiber/SFP model
Figure 3. Rear Panel
4. DIP SWITCH Setting
