9
CONTROLS
Controller Board
AHnet: PoE Connector
Use the power supply to connect the device. Connect an Ethernet CAT6
shielded cable to the output on the power supply and then connect the
CAT cable AHnet connector to the microphone lift. For remote control
using the AHnet, connect a CAT6 shielded cable to the input on the power
supply and then connect the cable to the network. Connect the power
supply to the power source.
The device is powered and connected to your network. Minimum power
required 30W PoE. For remote control see AHnet protocol.
Controller Board Settings
Deep1: Wireless connection ON/OFF
Down position: Wireless connection active
Up position: Wireless connection not active
(Leave the rest of the deep switches in up position)
SERVICE: USB, service only
MIC: Microphone RJ45. SHURE MXA310 RJ45 connector
