Artel DigiLink DLC910, Инструкция по установке и эксплуатации

Страница: 20 / 28

10 DLC910 Function Module Installation and Operations Manual
DLC910 Function Module
Monitoring DLC910 Operations
This section describes how to monitor DLC910 operations using the front and rear panel status LEDs or
DigiLink Manager and contains the following topics:
• Using the Module Status LEDs (page 10)
• Using DL Manager (page 12)
Using the Module Status LEDs
This section describes how to monitor the module’s operations using the front and rear panel LEDs and
contains the following topics:
• Understanding the Front Panel Status LEDs (page 10)
• Understanding the Rear Panel Status LEDs (page 11)
Understanding the Front Panel Status LEDs
Table 2 describes the states of the DLC910 front panel status LEDs as shown in Figure 6 .
Figure 6. DLC910 Front Panel Status LEDs
Table 2. DLC910 Front Panel Status LEDs
LED Indicates . . . State Description
OK Module status Off No power or unprogrammed.
Green Normal operation.
Yellow Minor alarm condition exists.
Yellow (flashing) Field upgrade in progress.
Red Major alarm condition exists.
QUADRANT
1, 2, 3, 4 Input status Off Not enabled.
Green Valid SDI signal detected.
Yellow Enabled but no valid input signal detected.
Red Unsupported input signal detected.