loses power (which causes the unit to go into bypass), the signal will be equal or lower than the active
eq gain. This will ensure that a signal with undesirably higher levels will not be passed inadvertently.
8. FDC LED INDICATORS
Each frequency band of the equalizer has a Feedback Detection Circuit LED, showing its relative
feedback level. These LEDs glow red, then become brighter as feedback begins to occur. Use the
individual frequency faders when adjusting the output level to reduce and eliminate feedback.
9. LED-LEVEL METER
Each channel of the equalizer has an LED level meter, showing its output level. The ”0” level is
calibrated to +4dBu. Use the level meter when adjusting the output level Control to aid in sending the
proper level to your next piece of equipment.
REAR PANEL CONNECTORS & CONTROLS
10. POWER CORD
This cord is used connect the AC power source to your equalizer. CAUTION: Equipment for USA
installation includes a captive power cord with a three pin polarized plug. DO NOT REMOVE THE
CENTER GROUNDING PIN.
11. FUSE HOLDER
This fuse holder contains the AC primary fuse. This fuse should be replaced with the same type fuse
if it is blown. If they continuously blow, stop replacing fuses and refer servicing to qualified personnel.
CAUTION: After checking the AC supply voltage, be sure that the correct fuse is in the fuse holder -
0.5Amp for 95-125VAC, as well for 220-240VAC.
12. AC VOLTAGE SELECTOR
Set this slide switch to match your line voltage supply. CAUTION: For new installations and portable
7
