readjust the level control.
INITIAL SET UP
Here are some tips to help you with the initial set up:
1. Set channel levels to the center detent 0dB on the front panel.
2. Select the Bypass switch to bypass the equalizer (Note: The red LED is on).
3. Set the frequency slide controls to the center detent (or 0dB).
4. Select the 6dB range switch (Note: The green LED is on).
5. Apply signal to the system.
6. Release the bypass switch (Note: The red LED is off).
7. If the Clip LED is on, you must turn down the input level control.
8.You may now start equalizing your system.
9. If you do not have enough gain for your needs, switch the range switch to the 12dB setting.
10. If the Clip LED lights continuously, turn down the level control until the LED is off most of the time.
FRONT PANEL CONTROLS
1. POWER SWITCH
To turn the equalizer ON or OFF, press the upper or lower portion of this button. CAUTION: Always
turn on your equalizer BEFORE your power amplifiers are turned on, and always turn off your equal-
izer AFTER your power amplifiers have been turned off.
2. FILTER LEVEL CONTROLS
Each of these sliders controls the output level of each of the 31 (or 15) bandpass filters. A detent at
the center position helps center the controls for a flat response.
3. FILTER RANGE SWITCH & INDICATORS
The gain range of the filter sliders is switchable (as a group) from +/- 6dB to + /-12dB for maximum
5
