The heating panel is provided with a pigtail cable or a main plug. In
the event of a pigtail plug, the wiring should be carried out by a
qualified electrician to a standard, suitably rated junction box. The
junction box supply will, then, be connected and switched by the
wall mounted thermostat, placed in the desired location, and wired
according to the instructions provided.
Electrical Connection
Please note if you are hardwiring this appliance, have a licensed
electrician install the electrical.
Alternately, the thermostat can be connected directly to the panel.
In the event a 110v plug is used, the supply line to the socket can
be switched using our current switching thermostat. Acceptability
of this method will vary by jurisdiction, and local laws or building
codes may prohibit this form of installation.
If you wish to have your panel hardwired, contact a local electrician
to have an installation compliant with all relevant local and federal
laws and codes.
Before Initial Start-Up
Checklist
You have read the safety instructions and this manual before
use.
You have made sure you are compliant with the instructions
herein.
You have checked the heating panel for any visual damage.
You have connected the panel to a voltage as required for this
panel (110-120Volts, 60Hz).
You have installed the panel in accordance with local and state,
provincial and federal regulations.
.
.
