Arrowquip Q-POWER 107 Series, Руководство по эксплуатации продукта

Страница: 50 / 52

1. Rear jacks are not synchronised.
a. If one cylinder is contacting the ground significantly ahead of the other, retract the jacks all
the way up and deadhead the jacks until both are as far retracted they can go.
i. This should be done every time the jacks are retracted.
b. Extend the jacks again to see if the feet are synchronised and contacting the ground at the
same time.
c. If the jacks are still not synchronised when they hit the ground, ensure the unit is charged f
fully or boost with jumper cables.
d. When both jacks are contacting the ground simultaneously, it is safe to lift the unit.
2. Battery is dead and/or the unit will not function.
a. Ensure pendant button is working.
i. Listen for the click of the relay when button is pressed. If it makes a clicking sound, the
relay is activating.
b. If the system seems dead and no functions are working, it is likely the battery may be low
and in need of charge.
c. Use an AGM Battery Charger to charge the unit, or boost by attaching jumper cables to
the charging lugs on the outside of the box.
i. Arrowquip recommends Genius 26000 Charger.
3. Slow function in extreme cold weather.
a. If the unit has been sitting outside in extremely cold temperatures, it is possible that the oil
is thicker than normal, and the jacks may operate slower than at warmer temperatures.
4. Unusual sound coming from the pump.
a. If it sounds like there is air getting into the hydraulic system, there is likely not enough oil
in the reservoir.
b. Fully retract all cylinders.
c. Check the oil level in the reservoir.
d. The oil level should be just below the edge of the port.
e. Fill or replace the oil, as necessary.
MANUAL JACKS
1. Manual winder is stiff.
a. Check that bearings are oiled.
b. Check for obstructions.
i. Inspect moving components of the jacks, to ensure nothing is damaged or
obstructing normal operation.
2. Manual winder is locked solid.
a. Check that bearings are not seized.