6
GROUP BYPASS
Instead of bypassing zones individually, your installer may have assigned several zones
together to be bypassed all at one time. An example would be turning off all the interior
zones of the premises allowing movement, while still protecting the perimeter.
Example: Interior zones 2, 3 and 4 have been assigned as GROUP BYPASS zones. To
bypass zones 2, 3 and 4 enter the following key sequence:
Figure 5
0
✚
✚
▲
#
●
3
■
4
●
1
2
ACCESS CODE
Zones 2, 3, and 4 will BYPASS but the other zones will ARM. This is a very easy way
of arming a part of the system all at one time. The display will show ARMED.
INSTANT/DELAY MODE
The system will normally arm in the Delay Mode when leaving the premise. This will delay
arming, allowing time to exit. When entering, the alarm will be delayed allowing time to
disarm the system. The audible warning device will sound during the entrance delay
reminding you to disarm the system. The Instant Mode is primarily used in residences.
It is used during sleeping hours when an entrance delay is not wanted.
If the Instant Mode is desired, enter the key sequence as follows:
Figure 8
0
✚
▲
*
✚
✚
▲
#
●
3
●
1
2
■
4
ACCESS CODE
The LCD display will show ARMED INSTANT .
PANEL TEST MODE
Your alarm system and its associated components (intrusion detectors, smoke detec-
tors, etc.) should be tested periodically. You can test these devices yourself using the
panel test mode. While in test mode the keypad beeps continuously to tell you it is in test
