4
A
Green
READY Light
when on indicates that all protected areas are secure and
system is ready to be armed. A blinking ready light indicates a Fault Condition.
B
Red
General ARMED Light
when on indicates system is armed or on. A blinking
armed light indicates that an alarm has occurred.
C
--The "
LCD DISPLAY
" indicates system status in english, with zone arming, zone
bypassing, alarms and trouble conditions all being displayed. System information such
as AC FAIL, LOW BATTERY, and FAIL TO COMMUNICATE along with ZONE DESCRIP-
TIONS will be displayed when needed to clearly show the current condition of the
system.
NOTE: This manual will use the default descriptions when referring to the LCD
display, and assume Auto Scrolling is enabled. These descriptions may
be changed by your installer.
DISARMING AND SILENCING THE SYSTEM
(when ARMED light is on)
To Disarm your system (assume Access Code 1234), enter your Access Code, key
sequence as follows:
Figure 2
✚
▲
#
■
4
●
1
●
3
2
ACCESS CODE
If you disarm your system, the armed light (RED) is off and the LCD display will show
READY if all zones are secure, or NOT READY if one or more zones are not secure. If you
silence the system after being in ALARM the LCD display will show the zone description
of the zone that was in alarm. This is called ALARM MEMORY. It will be cleared the next
time the system is ARMED. The 24 Hour zones will remain on all the time and they can
be displayed by using Fault Analysis Mode.
RECOMMENDATION: If, when arriving home, the burglar alarm is sounding,
contact police from a nearby location. DO NOT ENTER YOUR RESIDENCE.
