Blade Lock
A
B
C
D
H
G
F
E
DEFINITION OF SYMBOLS USED ON TOOL
Use dust mask. Dust which is
injurious to health can be
generated when working on
wood and other materials.
©
RPM
Revolutions Per Minute
Safety alert
min
Minutes (time)
S
Seconds (time)
Ø
Diameter (size of drill bits, grinding
wheels, etc.)
UL Listing for Canada and U.S.
No load speed (rotational speed at no
load)
0
n
0
Off position (zero speed, zero torque...)
1,2,3, …
Selector settings (speed, torque, or
position settings. Higher number means
greater speed)
W
Watts
A
Amps
HZ
Hertz
V
Volts
1. Lift the quick release lever and push it firmly forward over
2. Place the tool upside down on a flat surface.
4. Clean flange and accessories of all dirt and debris.
that are attached incorrectly or are not securely fixed in
To reduce the risk of injury, keep hands away
from the blade and all moving parts.
Always wear proper eye protection marked to
comply with ANSI Z87.1.
When working in dusty situations, wear
appropriate respiratory protection or use an
Observe correct main voltage! The voltage of
specified on the nameplate of the machine.
Cat. No:
Voltage & Frequency:
Motor Power:
No Load Speed:
OSC9500-A
120V/60Hz
4 A
Oscillating Angle:
5 Degrees
8,000-16,000/min
1. Lift the quick release lever and push it firmly forward over
2. Place the tool upside down on a flat surface.
4. Clean flange and accessories of all dirt and debris.
that are attached incorrectly or are not securely fixed in
To reduce the risk of injury, keep hands away
from the blade and all moving parts.
Always wear proper eye protection marked to
comply with ANSI Z87.1.
When working in dusty situations, wear
appropriate respiratory protection or use an
Observe correct main voltage! The voltage of
specified on the nameplate of the machine.
Gear Box
Lever
On/Off Switch
Speed Control Dial
Draw-in Bolt
Air Vent
A
B
C
D
E
F
Air Vent
G
Tool Hanger
H
1. Lift the quick release lever and push it firmly forward over
2. Place the tool upside down on a flat surface.
4. Clean flange and accessories of all dirt and debris.
that are attached incorrectly or are not securely fixed in
To reduce the risk of injury, keep hands away
from the blade and all moving parts.
Always wear proper eye protection marked to
comply with ANSI Z87.1.
When working in dusty situations, wear
appropriate respiratory protection or use an
Observe correct main voltage! The voltage of
specified on the nameplate of the machine.
SYMBOLS
FUNCTIONAL DESCRIPTION
WARNING!
Only use accessories
specifically recommended for this tool.
Others may be hazardous
7
