Instructions
Wall-mounting instructions
Note
:
When mounting the Telephony Modem on drywall, try to position the
Telephony Modem so at least one of the screws is fastened to a stud.
This may prevent the Telephony Modem from pulling out of the wall in
the future. To prevent overheating of the Telephony Modem, do not block
the ventilation holes on the sides of the unit.
1
Position the Telelphony Modem on the surface where you intend to mount it.
Orient the Telephony Modem with the indicator lights facing up or right, as
desired.
2
Drill two holes, 4 inches (102mm) apart, in the correct locations for the
mounting screws.
3
If using drywall anchors, set them into the wall. Then, drive the screws into
the wall leaving a gap of about 1/8” (3 mm) between the screw head and
the wall. If not using anchors, just drive the screws.
4
Slip both mounting slots (in the back of the Telephony Modem) over the
screws, then slide the case down until the narrow end of the keyhole slot
contacts the screw shaft.
5
Connecting the Telephony Modem
Desktop mounting instructions
1
Position the Telephony Modem so that:
• air flows freely around it
• the back faces the nearest wall
• it will not fall to the floor if bumped or moved
• the ventilation holes on the side of the unit are not blocked
2
Connecting the Telephony Modem
Touchstone TM1602G Telephony Modem User’s Guide
23
Step 1
Step 2
Step 4
Step 3
