M90 - Service Manual
Service Manual / October 16, 2013
Arnold & Richter Cine Technik GmbH & Co. Betriebs KG, Pulvermühle, 83071 Stephanskirchen
L5.37566.D
Website:
www.arri.com/service-lighting
Seite
3
von
25 | Page 3 of 25
Safety Instructions
The following instructions contain helpful advice on how to operate your ARRI lamp head
safely. Lamp heads, lamp head systems and accessories may only be operated and used
by qualified persons and only for professional lighting purposes. Relevant operating
instructions must be followed for the equipment you are using. Please also refer to the
Ordinance on Industrial Safety and Health as well as the relevant guidelines and
regulations of your national Industrial Injuries Corporation (e.g. BGI 810-1, -3 and -4, BGV
A1 for Germany; OSHA or ESTA for USA; etc.). Please refer also to our leaflet "Operating
your ARRI Lamp heads safely"
L5.70431.E
.
General Safety Requirements for Operating Lamp head Systems
a) Safety Requirements for Transport, Setup and Operation of lamp heads
» Please make sure that the bulb has been removed before starting transportation. The
vibration during transport can cause damage to the bulb and the lamp socket.
» We recommend wearing suitable protective clothing when working with lamp heads in
order to prevent injuries and burns (e. g. from ultraviolet radiation).
» In the interest of your own health and safety, we advise you to consider the weight of
your lamp head and accessories when carrying or lifting them and to observe the relevant
precautions recommended by your Occupational Safety and Health Administration (for
Germany BGI 810-1).
» Please ensure that all electrical cables are routed in such a way as to prevent tripping
hazards and damage by vehicles. You can achieve this with the help of suitable signs,
covers or cable crossovers.
b) Safety Requirements Concerning Electrical Danger
» Please check the lamp head system and its electrical protection device before each use.
» The faultless function of the power supply and protection system must be ensured
before connecting the lamp head (e.g. grounding, circuit breaker).
It might be necessary to install additional protection measures; for example:
» the application of residual current operated protective devices (RCDs)
» the application of safety extra low voltage, protective separation or protective insulation
» equipotential bonding
