10
film
gate
locking
lever
Installation
film gate
movement
locking lever
knurled knob
filter
holder
format mask
film gate
shaft
4.2 Preparing
the Film Gate
To accomodate the movement of the pulldown claw during
film-transport, the film gate is designed with vertical slits
on both sides. Furthermore, there are two holes for the
register-pins. These openings must be covered to prevent
stray light from reaching the film.
To enable the shutter plate of the Integrated Capping Shutter
to slide into the film gate, a special guide is inserted into the
film gate in place of the filter holder. The plate then slides
into this ICS-Guide. Due to the form of the ICS-Guide it is
necessary to use special format masks.
• Before removing the film gate turn off the camera’s main
switch and remove the camera from the power supply.
• Turn the knurled knob
➪
photo
until its marking
matches that on the movement block.
• Turn the movement locking lever
➪
photo
to the “OPEN”
position. This will cause the movement block to swing
away from the film gate.
Содержание ICS-1
