ARRICAM Studio Quick Guide 01/2004, Page 11 of 20
Changing fps
Fps is set on the Standard Camera Control Panel by pushing the FPS selector buttons with a small pointed tool
while the camera is in standby. Fps is set on the Extended Camera Control Panel by first pressing and holding
the UNLOCK button then using the FPS selector buttons while the camera is in standby.
Note:
Before entering the desired fps on the Camera Control Panel, ensure that no other component has control
of the camera, e.g. if the Speed Control Box is attached, its SPEED CONTROL switch has to be set to OFF. Simi-
larly, if the Manual Control Box is connected to the camera, its MANUAL CONTROL switch has to be set to OFF
or to SHUTTER .
Changing shutter angle
To change the shutter angle with the Standard Camera Control Panel, press the SET shutter angle selector with
a small pointed tool. On the Extended Camera Control Panel, it is necessary to press and hold the UNLOCK
button while pressing the SET shutter angle button.
With either panel, each pressing of the SET shutter angle button will cycle through following values:
180°, 172.8°, 150°, 144°, 135°, 120°, 105°, 90°, 86.4°, 75°, 60°, 45°, 43.2°, 30°, 22.5°, 11.2°.
Note:
Before entering the desired shutter angle on the Camera Control Panel, ensure that no other component has
control of the camera, e.g. if the Manual Control Box is attached to the camera, its MANUAL CONTROL switch
has to be set to OFF or to FPS. If the SCB is attached to the camera, make sure that its COMPENSATION switch is
set to OFF or to IRIS.
RUN LED
PHASE button
PHASE button
SHUTTER angle display
FPS selector
FPS display
RUN LED
FPS selector
RESET button
Film length (EXPOSED
FILM) display
BRIGHT button
SET shutter angle selector
RAW STOCK button
UNLOCK
button
RUN/
STOP
button
SET shutter angle
selector
SHUTTER angle display
FPS display
FPS selector
RUN/STOP button
Studio Standard Camera Control Panel
Studio Extended Camera Control Panel
Basic Camera Operations
