Revision 1.5 November 21, 2011
P a g e
|
5
2 Bandmaster III Hardware
Configuration
In this section we will look at the different ways of configuring the
Bandmaster III
hardware.
The unit may (should) be configured via the
Bandmaster III
software (preferred method) or by
DIP switch settings on the Bandmaster III circuit board.
Note: When using the decoder with the optional 4-Wire Network control system you *must*
use the software configuration option.
Band Data:
Yaesu / Elecraft Band Data users will configure the Bandmaster III for “Band Data”
as the Radio Model as shown in the following image (i.e.; Band Data should be chosen instead of
the radio model):
The interface type is automatically determined from the radio type. Switch settings are dependent
on which configuration mode you select, manual or software. A
‘0’
in the tables indicate OFF and
‘1’
indicates ON. Switch settings are:
