12
11 CARTRIDGE REPLACEMENT
22
15Nm
41
15Nm
3.
5.
4.
Before replacing the cartridge make sure:
1.
The cartridge filter is not blocked with debris.
If debris is found, clean the filter.
2.
Check the pilot hole in the cartridge is clear.
For more details see section 10.
After cleaning, refit the cartridge & recheck the product
Handle removal: Firstly remove the handle as detailed in section 9.
ENSURE WATER SUPPLIES HAVE BEEN ISOLATED.
3
. With the handle removed, use a 41mm A/F spanner to unscrew the chrome
shroud.Lift off the chrome shroud complete with brass adjusting ring.
4.
The cartridge & brass housing assembly can now be lifted out of the mixer
body.
5.
The cup seal can be lifted out of the mixer if necessary.
To remove the cartridge from the brass
housing, see section 10. A 22mm
A/F spanner is required.
To reassemble
Fit a new cartridge into the brass housing
& tighten to 15Nm. Use a vice if necessary
(taking care not to damage parts).
With cup seal in position, slide cartridge
& brass housing assembly into
the mixer body. Ensure the
lobe on the brass housing is towards
the rear of the mixer as shown.
Replace the chrome shroud with adjusting
ring & tighten to 15Nm.
Adjust the run time as detailed in section 9.
Finally refit the handle.
TAKE CARE NOT TO DAMAGE CHROMED SURFACES.
