9
Installation
Advisory
Before operating the equipment, it must be unpacked, assembled and installed as
described in the steps that follow. Safe use of the equipment depends on following
the correct installation procedure.
Installing the PC Software
Before operating CEM-MKII it will be necessary to install the software from the CD-
ROM supplied with CEXC onto an appropriate PC (PC not supplied).
For instructions on how to install and run the software insert the CD-ROM into the
optical drive on the PC (PC not supplied) then choose ‘Help’ from the menu.
After installing and running the software on the PC, instructions on how to operate
the software can be obtained by choosing the ‘Help’ tab in the top right hand corner
of the screen as shown below:
Note that when operating the software for the first time it will be necessary to enable
the USB virtual COM port by choosing the Red telephone icon (Start COM session).
Full instructions about enabling the port are included in the Help menus.
Installing the Equipment
Mounting the CEM MKII onto the CEXC
Fit the CEM-MKII assembly to the CEXC using the 4 locating studs and black
thumbnuts. The reactor is supported by 3 pillars; position the reactor on the
CEXC so that a single pillar support is at the front.
Connect the two flexible pipes from the feed pumps to the connectors on the
base of the reactor as shown.
Connect the electrical plugs from the conductivity probe, temperature sensors
T1 & T2 and the stirrer to the sockets located on the rear of the CEXC. For
normal use the conductivity probe should be connected to the socket marked
