Armada Technologies
Pro900 LOCATOR USER GUIDE
4
the traditional bladed end into a wall outlet. The transmitter is
then powered by AC mains voltage instead of batteries.
The Pro900 transmitter also can use
8 “D” (LR20) alkaline batteries that
are installed inside the transmitter battery compartment. Remove the
battery compartment cover and install the batteries, paying particular
attention to the positive and negative poles.
A 9-volt square (6LR61) alkaline battery is needed for the Pro900
receiver. To install this battery, remove the battery compartment cover
located on the back top portion of the Pro900 receiver. Install the 9 volt
battery by connecting it to the battery snap boot inside the battery
compartment. Don't yank or pull hard on the battery boot. Finally,
replace the battery cover.
To test that the batteries have been correctly installed, turn each unit on.
The control panel LCDs will come on if the batteries have been
connected correctly. If not, repeat the installation procedures. The
battery compartment is designed to hold the batteries tightly so if you do
not get a signal for power, try adjusting the batteries by rolling them or
moving them forward and backward until the power does come on.
Battery Condition Indicators -
There are low
battery indicator symbols on the left edge of both the
transmitter and receiver display panels. These
“fuel
gau
ge” battery symbols will be solid when fresh and
diminish to empty as the batteries are depleted.
