Remote Control
10%
100%
50%
WARM
COLD
NEUTRAL
BRIGHT
–
C/T
+
C/T
–
BRIGHT
+
Incrementally
adjust the color
temperature
of the lighting
up or down
Quick access
to preset color
temperature
levels
Quick access
to preset
light levels
Turn lights ON
Turn lights OFF
Incrementally
adjust the
brightness
of the lighting
up or down
Remote indicator
On/Off
The controller will remember the controller
state when powered off, and will return
to that state when powered back on.
Brightness adjustment
Press the “+” and “–” keys to adjust brightness
or press the 10%, 50%, and 100% keys to
jump to the specific brightness level.
Remote indicator
When pressing keys, the indicator blinks if the remote
is working properly. If the indicator flashes slowly
when pressing keys, battery power is low and it needs
to be replaced. Replace with a CR2032 battery.
Remote control operation
Using the remote control
Pull out plastic battery insulation tab before use.
The RF wireless remote will work through non-metal
walls and doors. Do not install in a metal enclosure.
Pairing with a new remote control
The remote control and receiver are already paired,
but up to 5 remotes can be paired to one receiver.
To pair a new remote:
1. Disconnect power to receiver
and wait five seconds.
2. Reconnect power.
3. Within ten seconds, press the “C/T –” and “C/T +”
keys simultaneously for about three seconds
until the remote indicator flashes quickly.
De-pairing remotes
To de-pair a remote control, pair the remote you
wish to continue using with the controller and
any other paired remotes will be de-paired.
Safety protection
The controller has built-in protection for incorrect
wiring, output short circuiting, overloading and
overheating. If the any of these conditions occurs,
the receiver will automatically shut down until
the issue is corrected. If this occurs, check
to make sure the connected LED lighting is
rated for constant voltage current and is in the
controller’s voltage output range. Also, make sure
all cables are securely connected and insulated,
and that the receiver is well ventilated.
Specifications
Output mode ..........................PWM constant voltage
Working voltage .......................................5–24V DC
Brightness grade ....................................... 11 levels
PWM frequency ............................................. 1KHz
PWM physical grade .................................256 steps
Overload protection ............................................Yes
Overheat protection ............................................Yes
Remote frequency .................................433.92MHz
Remote control range ....... >49 ft./15m in open areas
Controller dimensions .......... 3.43 X 0.95 X 0.59 in./
................................................... 87 X 24 X 15mm
Remote dimensions ........... 3.41 X 1.42 X 0.329 in./
............................................... 86.5 X 36 X 7.5mm
4
5
Customer support
Email: [email protected]
Phone: 410-354-6000
Monday–Friday, 9 a.m.–5 p.m., ET
Three-year limited warranty
This product is for dry location use only. Improper
installation, improper powering, abuse, or failure
to use this device for its intended purpose will void
warranty. Proof of purchase is required for all returns.
Questions? Email [email protected].
© 2021 Armacost Lighting. All rights reserved.
210601
armacostlighting.com
