2
INTRODUCTION
The Arlec Rechargeable Super Bright Quartz
Halogen Searchlight is a rechargeable torch
with a Quartz Halogen globe providing intense
white light.
BEFORE USE, CHARGE THE BATTERY
Plug the AC adaptor charger into the charger
socket on the torch by first lifting up the rubber
socket cover. Plug the adaptor into power and
switch outlet on. The time to fully charge the
battery is approx. 10 hours. The LED lamp next
to the charger socket on the torch will glow
whenever the charger is switched on.
NOTE: Both the switches on the torch must be
in the ‘OFF’ position for charging the battery.
On full charge the torch will operate for approx.
15 minutes before needing a recharge.
IMPORTANT: Do not store with flat battery.
Recharge regularly. If the battery is flattened
charge immediately. DO NOT CHARGE FOR A
PERIOD IN EXCESS OF 24 HOURS.
After charging close the rubber socket cover.
TO USE
The stand on the underside of the torch may
be set to a variety of angles just by rotating the
two sections into position. They will click into
place as they go around.
This can be used to set the torch at various
angles when setting it down on a surface to
direct it in a particular place, or allow hands
free use.
The stand can also be used as an alternative
handle.
Switch on by operating the switche at the
upper side of the torch near the handle at the
rear of the reflector.
Make sure the torch is switched off while
charging, as the charger will not function
while the torch is switched on.
WARNINGS
- Lens becomes very hot during operation.
This torch is designed for intermittent use
only. Continuous use is specifically not
recommended and may cause damage to
the unit.
- Never cover lens and reflector during
operation.
- Do not shine directly into eyes.
- Switch off the torch and allow to cool before
storage or maintenance.
- Replace the globe or battery with same
rating and type only.
- Use only the chargers supplied with the
lantern.
GLOBE REPLACEMENT
1. Remove the front of the torch by removing
the 4 small retaining screws and turning front
rim anticlockwise.
2. Lift out the reflector assembly and remove
the spring wire clip from the rear of the
reflector. Globe will now come away from
reflector.
Normal Position
Base unfolded
RT3500 inst. 8/11/07 10:19 AM Page 3