4
Temporary Location
The air outlet duct maybe fitted directly
into the circular opening of the foam strip
supplied to provide a temporary type
installation in a window opening. The
foam strips can be cut or trimmed to fit
the desired shape.
Permanent Location
The round connector (item 4) may be fit-
ted into a circular opening cut into a wall
or glass window. This connector, when
not in use, can be left in position with the
opening covered by the cap provided.
ASSEMBLY
Fitting the air outlet duct
This air conditioner is required to have
the air outlet duct fitted to an external
opening to exhaust the hot air.
The duct can be extended from 39cm to
150cm long, however it is recommended
to use the shortest possible length.
Prevent any bow or bend in the middle of
the duct, as this will trap hot exhaust air,
which will radiate into the room and
cause the unit to shut off automatically
(due to overheating).
IMPORTANT! The duct length has
been specifically designed for this
product. Do not replace or lengthen
the duct with attachments.
If the venting of the exhaust air is
inhibited in any way the unit may
over heat and shut off.
The location may be either a temporary or
permanent type depending on your
requirements. If you wish to frequently
move the unit from room to room without
creating a permanent opening in a wall or
window, you can use the foam strips as
described below under temporary location.
If you wish to have an place set aside
where you can connect and operate the
unit on a continuous basis you can use
the round connector, as described below
under permanent location
CPIN_518-2 15/9/04 5:08 PM Page 4