2
SAFETY INSTRUCTIONS
•
DO NOT use this unit for functions other than
those described in this instruction manual
•
DO NOT tilt the unit. Always keep in upright
position. If unit has not been kept in upright
position, wait for at least 24 hours before
operating the unit.
•
DO NOT cover or obstruct the air inlet or out-
let grilles
•
DO NOT use the unit in a wet room, such as a
bathroom or laundry
•
DO NOT sit or place articles on the unit
•
DO NOT touch the unit with wet hands or
bare feet
•
DO NOT let chemical substances come into
contact with the unit
•
DO NOT use the unit in the presence of
inflammable substances or vapour such as
alcohol, insecticides, petrol etc.
•
DO NOT use the mains plug to start and stop
the unit
•
DO NOT pull the supply cord or
place it near a heat source. Always unwind
the cord completely to avoid overheating. If
the supply cord is damaged it must be
replaced by the service agent or a similarly
qualified person, in order to avoid a hazard
•
DO NOT allow children to play with this
appliance. This appliance is not intended for
use by children or infirm persons without
supervision.
•
DO NOT conduct repairs on this unit. It has
been built in accordance with relevant safety
and performance standards. An electrical
specialist must carry out all repairs.
•
DO NOT use the unit without the filter fitted
•
ALWAYS unplug the unit from the mains
before maintenance or
cleaning
•
ALWAYS use the switch on the
control panel to start and stop the unit
•
ALWAYS keep a clearance of at
least 50cm from walls furniture and curtains
•
ALWAYS turn off the unit when not
in use
ENERGY SAVING TIPS
•
Use the unit in the recommended room size
of up to 20m
2
(assuming standard 2.4m ceiling
height)
•
Do not locate the air conditioner where fur-
niture or other objects can obstruct the air
flow.
•
Keep blinds/curtains closed during the sun-
niest part of the day
•
Close the fireplace damper, floor and/or wall
registers, so cool air does not escape
through the chimney or duct work
•
Keep the air filter clean
•
Set the unit to maximum cooling and high
speed ventilation for the initial startup, then
adjust the unit down to a more comfortable
setting as required
CPIN_518-2 15/9/04 5:08 PM Page 2