1. for using the fan as a table fan
remove the sub assemblies for the
stand and assemble the stand as
shown in (Figure 9).
2. Attach the motor housing to the
stand. remove the bolt and the
nut attached to motor housing and
attach the motor housing to the
stand as shown in (Figure 10).
3. follow steps 6-8 from the floor
standing assembly instruction for
attaching the grille and the fan blades.
4. Attach the switch control box to
stand, 2 mounting holes are provided
on the stand to attach the switch
6
7
Care anD maIntenanCe
teChnICal SPeCIFICatIOnS
OPeratIOn
control box (Figure 11).
1. The fan assembly wall mounting
is same as the table fan assembly.
The stand is attached to the wall
mounted hooks.
2. Two wall mounting hooks are supplied
with the kit. Select a mounting
position. hold the hook in place and
mark the screw location. The two
brackets must be 197mm apart as
shown in Figure 12. drill holes and
attach the hook to the wall using
6 screws and wall plugs supplied
with the unit. (3 screws
and wall
plugs per hook) Care
should be taken to
avoid drilling or
screwing into concealed
electric wiring.
3. hang the fan stand to the hooks
(Figure 12). Adjust the fan head by
loosening the nut attached to the
stand. Tighten the nut once the
table Fan aSSembly
wall mOUntInG
desired angle is achieved.
The fan is now ready to use.
1. Make sure you read all the safety
warning before first time use.
2. Plug the cord to a mains socket
and turn on the mains switch.
3. The speed control switch box allows
three speed settings “1-2-3”, “0”
is the off position.
4. Press the desired speed setting
button and the fan will run
continuously at selected speed.
5. Press the oscillation switch located
at top of the motor housing and
the motor will move side to side.
Pull the switch up and the fan will
stop oscillating.
1. Always disconnect the cord from the
electrical outlet when cleaning your fan.
2. Light accumulated dust may be
removed from the fan with a soft
cloth or vacuum cleaner using the
dusting brush attachment.
3. To remove the front grille unscrews
the screw located at the bottom of
the front grille, pull the 4 grille
locking clips up (away from the
grille) and slide the front grille out.
4. Clean the dust accumulated on
the fan blades using a soft cloth
or vacuum cleaner using the dusting
brush attachment.
5. Attach the front grille, align the
screw hole on the front and the rear
grille and press the locking clips
against the grille to lock them in.
Put back the screw and nut.
Never operate the unit without the
front grille assembled.
4. Wipe the exterior surfaces of the fan
occasionally with a cloth moistened
(not dripping wet) with a mild soap
solution. dry the fan thoroughly
with a soft dry cloth before
operating the fan. Speed control
box is not of weather proof
construction so make sure you do
not spill any water over the switch
box while cleaning the unit.
5. Avoid the use of gasoline, benzine,
thinner etc as they may result in
damage to the fan.
6. Store the fan in a clean dry place
when not in use.
WarNINg: DO NOT ImmerSe The
FaN IN WaTer Or aLLOW WaTer TO
DrIP INTO The INTerIOr OF
The FaN hOuSINg aS ThIS COuLD
CreaTe a FIre Or eLeCTrIC
ShOCk haZarD.
model No:
aFF003
rated Voltage:
220-240Vac
rated Frequency: 50hz
Power:
60W
Current: 0.32a
Figure 9
Figure 10
Figure 11
Figure 12
197mm
CPIN002509/2