Page | 34
Commercial in confidence. User Manual Revision CTK-SM-REV8-060720
6. SERVICING INSTRUCTIONS
- Continued
6.20 Junction Box / Under Bed Light - Replacement
(Refer Figure 4.)
Removal
a) Raise the mattress platform to the maximum height and remove seat cover (figure 7
item 41). Unplug the bed from mains power supply socket.
b) Release junction box cable retainer (8) by inserting a small flat screwdriver into the
slots on the front of the junction box to release the clips (A) (refer figure 18).
c) Pry off retainer by inserting screwdriver under the two tabs (B) on the bottom face of
the junction box (figure 18).
d) Pull off the retainer and put it aside.
e) Unplug the control cables (10, 11 & 22) and blanking plug/s (9) (if fitted) from the
junction box.
f) Remove two pan head self-tapping screws (C) securing the junction box to the bed
frame (figure 18).
Installation
a) Secure junction box (8) to the bed frame using existing self-tapping screws (C),
observing junction box orientation so that cable ports are facing towards the middle
of the seat.
b) Plug in control cables (10, 11 & 22) and blanking plug (9) (if fitted).
c) Install cable retainer face plate onto junction box (8).
