Aritech CyberDome, Инструкция по программированию

Страница: 8 / 40

6 CyberDome Programming Instructions
Menu Screen Function
Return Time
TIME BEFORE RETURNING
-- SITE 0000 --
INCREASE ( )
DECREASE ( )
ENTER TIME : 05M 00S
(ALARM)-HLP (SEQ)-NEXT
The period of inactivity (return time)
referenced in the Auto Return menu is set
with this menu. Use the
keys (or the
joystick) to increase or decrease the return
time in increments of 15 seconds, up to 5
minutes; then by 1 minute increments, up to
60. (15 sec~5 min, 5 min~60 min)
The minimum return time is 15 seconds. The
maximum return time is 60 minutes.
Day/Night Switch
DAY /NIGHT SWITCH LEVEL
-- SITE 0000 --
SWITCH LEVEL CHOICES :
0 : MANUAL SWITCHOVER
1-4 : LIGHTER THAN DUSK
5 : DUSK/DAWN
6-9 : DARKER THAN DUSK
ENTER SELECTION (1-9) :
(ALARM)-HLP (SEQ)-NEXT
The Day/Night switch is used to set the level
at which the camera’s infrared filter will
automatically switch in and out at dawn and
dusk. The light level switch-point is
adjustable, but should only be set during
dawn/ dusk conditions.
Selecting
0
will allow you to manually
activate the switch. If this option is selected,
contact the factory for proper keypad setup.
Note: The ATD-300 does not support manual
switchover.
Electronic Zoom
ELECTRONIC ZOOM
-- SITE 0000 --
1X (1)
4X (4)
ENTER SELECTION :
(ALARM)-HLP (SEQ)-NEXT
Used to set the electronic zoom on the
CyberDome. The factory default setting is 4X.
While in this menu, the zoom setting may be
tested by entering a selection and then
pressing the
zoom
out
zoom
in
keys.
Once the desired zoom setting is selected,
press
seq
to advance to the next menu.
Exposure Control
EXPOSURE CONTROL
-- SITE 0000 --
AUTO IRIS (0)
MANUAL IRIS (1)
MAN/RETURN TO AUTO (2)
ENTER SELECTION :
(ALARM) - HLP (SEQ) - NEXT
Pressing
0
enables the Auto Iris, where the
camera automatically adjusts to different light
levels. In Auto Iris mode,
iris
open
enables the
electronic shutter, and iris
closed
toggles backlight
compensation for image enhancement.
Pressing
1
allows manual control of the iris
using the iris
open
iris
closed
keys.
Pressing
2
will allow manual control of the
Iris and upon pan/tilt movement, the exposure
will return to the auto mode.
In all modes
iris
open
controls the shutter.