Aritech ACL800FL-CONV-W RS485, Инструкция по установке, Страница: 2 / 4

2 / 4 P/N 1073494-
EN • REV B • ISS 07JUL22
Configuration
From Web Browser
1. Write the IP as URL (default http://192.168.1 100).
2. Write the username and password (default Username:
admin; Password: 00000000).
Figure 4: Authentication and settings
From ACL800 BioManager
Right click on Portals, and select Search Network Portals.
Figure 5: Search Network portals
Click Search, then click the setup button for the connected
converter.
Figure 6: Search portals
Reset IP to defaults
Press and hold the tact switch for about 5 seconds until the
second green LED turns on. The tact switch is shown in
Figure 1 on page 1 as Reset.
The reset is applied to the IP address, the TCP port and the
password.
Advanced settings
•
Setup port: Network port for search and setup in ACL800
BioManager.
•
Password: Password for access to read and change the
settings of the converter. It is recommended to change the
default password and use it for all converters in the
system.
•
MAC: Physical address of the device.
•
DHCP Enable: Enable/Disable the DHCP client.
•
DNS: Address of the DNS server.
•
Data port: Port used for communication between the
Server and devices behind the converter. The same value
is used in the “Portal” in the software.
•
Dedicated client: When enabled, the converter will connect
only to PC with specified IP or MAC.
•
Version: Firmware version of the converter.