Ariston CPDO 110 AUS, Инструкция по эксплуатации, уходу и установке, Страница: 15 / 28

GB
15
When you first switch on the appliance you will be
prompted to set the “Time of Day” on the display.
You must ensure you have done this before
attempting to use the automatic cooking feature.
AUTOMATIC COOKING
The 1st oven can be controlled automatically.
HINTS ON AUTOMATIC COOKING
- Select food which will require the same cooking
time and temperature.
- To ensure food does not cool down and require
reheating, set the end time so the food is ready
when you require it.
- Always ensure that meat and poultry is defrosted
before placing in the oven.
- Whenever possible, take food out of the
refrigerator and keep it as cool as possible.
- If cooking food that requires frying before placing
in the oven for automatic cooking, keep the delay
time to a minimum.
- Never place hot or warm food in the oven for
delayed start cooking as it could cause the oven
to be warm and produce harmful bacteria in the
food.
- We advise that dishes containing left-over cooked
poultry and meat, eg. shepherds pie, should not
be cooked automatically if there is to be a delay
period.
- Ensure that delay start times are kept to a
minimum to prevent bacterial growth in food.
- Wine or beer may ferment and cream may curdle
during the delay period, so it is best to add these
ingredients just before serving.
- Foods which discolour should be protected by
coating in fat or tossing in water to which lemon
juice has been added, prior to placing food in the
oven.
- Dishes containing liquid should not be filled too
full to prevent boiling over.
- Food should be well sealed (but not airtight) in a
container to prevent the loss of liquid during
cooking. Aluminium foil gives a good seal.
- Always ensure that food is piping hot and cooked
thoroughly before serving.
- Only reheat food once.
SETTING THE TIME OF DAY:
Electronic Clock &
Automatic Cooking Feature
STEP 1.
Check the electricity supply to the cooker
is turned on.
STEP 2.
When switched on the display will show
both 00:00 and the “set time” symbol flashing. Wait
until these stop flashing.
STEP 3.
Press the Time/Mode button once, so that
the “Set Time” symbol and the display are flashing.
Turn the +/- control knob until the correct hour is set.
STEP 4.
Press the Time/Mode button once, so that
the “Set Time” symbol and the display are flashing.
Turn the +/- control knob until the correct minutes are
set. Press the Time/Mode button again.
TIME OF DAY IS NOW SET.
To alter the time of day after the first setting, simply
press the Time/Mode button.
The “Set Time” symbol and the display will flash.
Repeat STEPS 3 and 4.
SETTING THE TIME MINUTE MINDER:
STEP 1.
Press the Time/Mode button, until the “bell”
symbol is flashing.
STEP 2.
Turn the +/- control knob to set the duration
in minute increments until the required time is set.
After a few seconds the “bell” symbol will stop
flashing and the time will count down.
THE MINUTE MINDER IS NOW SET.
At the end of the set time an audible tone will be
heard and the “bell” symbol will go out. After a few
seconds the audible tone will stop and after a few
seconds the display will revert back to the time of
day. The minute minder can be cancelled at any
time by following
STEPS 1
and
2
, setting the time period to zero
using the +/- control knob.
The display will revert back to the time of day. The
display shows HOURS and MINUTES
eg. 1 hour 38 minutes