IPX-100 system installation & configuration
Page-89
TELECOMMUNICATIONS
5-10-1-1
General
a.
General
The general setting page sets the basic operating parameters of the outgoing route and
described as follows
：
Name
outgoing route name.
Outbound Code
Outbound code, as the basis for outbound dialing judgment
0~9 Must match the number.
N
Number 2~9.
Z
Number 1~9.
X
number 0~9.
Match Length of Prefix
Whether it meets the number of outgoing codes.
No The outgoing code is the prefix code, and the number of
dialed numbers must exceed the number of outgoing
codes.
Yes The number of dialed numbers must match the number of
outgoing codes.
Strip No
Strip the number of prefix number (for example, set to 2, dial
0285123000, actual dial 85123000).
Add Prefix
To add the prefix number in front of outgoing number.
b.
Using Trunks
At this page sets the using trunks.
The option shows the trunk line code and the type of trunk line (FXO, SIP). You can set the
trunk line used for routing and sort the order of the trunk lines. When using the trunk line,
select the trunk line according to the order.
Available/Selected Trunks The option can be multi-selected. Press the “Right” button from
the available trunk line to move to the list of selected trunk lines
to select the trunk line, and press “Left” to move to the list of
available trunk lines to cancel the use of the trunk line.
