Aristel AV SERIES, Руководство по программированию

Страница: 46 / 67

Revised by R. Robinson Issue AV1.13 8 June 2006 43
Zone 405 Toll (Plan = 1 of 10 toll groups for CO lines)
Default value = The restriction level for all CO lines, defaults to the same level as the plan (group) number
Range = 0~9
It is strongly recommended that Zone 405 be left in the default condition.
This Zone allows the programmer to set the restriction level for each CO line for 10 different groups.
Toll restriction works on a matrix principle as set out below:
TOLL LEVEL CO #1 CO #2 CO #3 ETC
0 0 0 0 0
1 1 1 1 1
2 2 2 2 2
3 3 3 3 3
4 4 4 4 4
5 5 5 5 5
6 6 6 6 6
7 7 7 7 7
8 8 8 8 8
9 9 9 9 9
If left in the default state, all CO lines will have the same toll level in any particular plan (group). The stations
are then assigned to a plan (group) in
Zone 503 Item 5 and Item 6 . However, it is possible to alter the levels of
any CO line for any plan. This will allow restrictions to be different for any one CO line depending on which
plan (group) is being used. Eg.: CO 1 could be 8 for plan 8, but CO 2 could be 0 for plan 8. This may provide
extensive restriction capability, but it is recommended that the default values be left in
Zone 405 .
TOLL LEVEL RESTRICTIONS.
LAYER FUNCTION RELATED ZONES
0 Unrestricted
1
local numbers assigned length only Zone 206 , Zone 257 ,
2 Only Common Allowed Codes Zone 406 , Zone 257 ,
3 Any numbers except Common
Disallowed Codes
Zone 407 , Zone 257 ,
4 Allowed to dial Area Code A,
Office Code A
Zone 408 , Zone 410 , Zone 257 ,
5 Allowed to dial Area Code B,
Office Code B
Zone 409 , Zone 411 , Zone 257 ,
6 Allowed to dial Area codes A and
B, Office Codes A and B
Zone 408 , Zone 409 , Zone 410 ,
Zone 411 , Zone 257 ,
7 Toll Private Line
8 Cannot access CO lines
9 Reserved
Related Zones. Z203 , Z503 Item 5 , Z503 Item 6 , Z257,