AN1204 3G Intercom
12
Revision E16
,Oct 2015
Programming by dial in
Note: programming dial in can’t be used from telephones which are already programmed to open the door
when they dial the 3G intercom but you can disable Caller ID display (withhold the number) on the mobile
before using.
To gain access to the programming mode via dial in, follows these steps:
Example:
Storing a telephone number for dial in door release
Enter Programming Mode by Pressing…..
*12*
1234
# (1234 is default password)
A successful pass code will produce a single long beep. A failed attempt will produce 3 short bleeps.
You may now program up to 1152 telephone numbers into memory.
Use the following commands to program the unit
* Insert international country code (1~3 digits):
71 [ country code] #
* Add a number (up to 1152 numbers):
72 [relay][telephone number] #
* Delete a number:
73 [ telephone number ] #
* Delete all numbers:
73*#
Door /Gate Release (ring in to open)
This 3G intercom also has an extra feature to allow user to gain access from their mobile phone by two
methods.
1. Caller ID recognition
2. by access control password mode
1. Caller ID recognition to open
Ring in to open the door for authorized telephone number. It can support for up to 1152 users.
When 3G Intercom receives a call from user, it will check the calling number and if the number is in the list,
the 3G Intercom will drop the call and then open the gate / door. The 3G Intercom doesn’t answer the call,
it simply checks the caller ID, and so it won’t cost you anything to open the gate / door.
