6
For round ducted discharge installations
Install 7” (17.8 cm) transition with its screws (purchase separately,
see Optional accessories and consumable parts section).
NOTE:
The round transition can be installed up to 1 inch on either
side of the hood center to accommodate off-center ductwork.
In extreme offcenter installations, one end of the duct connector
may need to be trimmed to clear the electrical cable clamp.
7” round transition
Mark and Cut Vent Opening
Use the hood as a template and mark the locations on the
cabinet for the keyhole screw slots.
Select the vent option that your installation will require and
proceed to that section.
For a non-vented (recirculating) installation
No additional steps needed.
Outside top exhaust
(Vertical duct– 3 1⁄
4
”x 10” Rectangular)
Use the diagram or the hood as a template and mark the
locations on the cabinet for ductwork, electrical wiring and
keyhole screw slots.
Centerline
Electrical access hole (in
cabinet bottom)
Wood shims (recessed
bottom cabinets only)
Hood mounting screws (4)
13
15
⁄
16
” (30” hood)
16
15
⁄
16
” (36” Hood)
13
15
⁄
16
” (30” hood)
16
15
⁄
16
” (36” Hood)
Cabinet front
Cabinet bottom
12
1
⁄
2
”
5
1
⁄
4
”
5
1
⁄
4
”
1
1
⁄
4
”
1
1
⁄
4
”
1
1
⁄
2
”
10
1
⁄
2
”
5”
Vertical duct
access hole
Outside top exhaust (Only recirculating version)
(Vertical duct–7” Round)
1.
Use the diagram or the hood as a template and mark the
locations on the cabinet for ductwork, electrical wiring and
keyhole screw slots.
Wood shims (recessed
bottom cabinets only)
Hood mounting screws (4)
13
15 16
” (30” hood)
16
15 16
” (36” Hood)
13
15 16
” (30” hood)
16
15 16
” (36” Hood)
Cabinet front
Cabinet bottom
12
1 2
”
1
1 4
”
1
1 2
”
10
1 2
”
5”
HOLE
Access hole for
7” round duct
Centerline
Electrical access hole
(in cabinet bottom)
8” DIA.
2.
Use saber or keyhole saw to cut a rectangular opening for
vent.
Choose Venting Option
The hood can be set to vent outside or to recirculate air back into
the kitchen. The plastic vent lever is located near the center of
the hood opening.
To vent to the outside, make sure the plastic vent lever is in the
HORIZONTAL position (flat against the metal top of the hood). To
recirculate air into the kitchen, make sure the plastic vent lever is
in the VERTICAL position (flat against the plastic blower housing).
NOTE:
In order to change the vent lever position, you will need to
pull the lever out slightly to clear the plastic tabs.
Hood shown lying upside down
Set for
outside venting
Set for
recirculating
Stop tab
Stop tab
