5
CAUTION:
Mount this hood so that the bottom edge above the
cooking surface is at 30” (76.2 cm) minimum if a gas range is
used or from 24” (61 cm) to 30” (76.2 cm) if an electric range is
used. Household use, please, read installation manual for specific
application. Check your ceiling height and the hood height maxi-
mum before you select your hood.
Venting through the roof
Non Vented (recirculating)
A
B
C
F
F
C
E
Venting through the wall
F
A
B
D
F
C
A
B
A. 6” round transition
B. 6” round duct system
C. Cabinet / Duct cover kit
D. 90° elbow
E. Recirculating kit
F. Installation height:
Gas range MIN: 30” (76.2 cm)
Electric range: from 24” (61 cm ) to 30”
(76.2 cm)
Installation Instructions
Ducting version
After having chosen the vent option, proceed as follows:
1.
Prepare duct and conduit cut outs as needed.
2.
If possible, disconnect and move freestanding or slide-in
range from cabinet opening to provide easier access to
rear wall. Otherwise put a thick, protective covering over
countertop, cooktop or range to protect from damage and
debris. Select a flat surface for assembling the unit. Cover
that surface with a protective covering and place all canopy
hood parts and hardware in it.
3.
Determine and mark the centerline on the wall where the
canopy hood will be installed. Select a mounting height
comfortable for the user and mark on wall
4.
Prepare duct and conduit cut outs as needed.
5.
Remove the duct knockouts using a flat blade screwdriver
and a small hammer.
6.
Use the screwdriver by knocking out the pannel in similar
fashion to a scalpel.
WARNING
Take care of knockout sharp edges.
A
B
A. Vertical discharge
B. Horizontal discharge
7.
Attach the 6” round air transition over knockout opening with
2 - 3.5 x 9.5 mm screws.
A
C
C
B
A. 6” round air transition (vertical discharge installation)
B. 6” round air transition (horizontal discharge installation)
C. 2 - 3.5 x 9.5 mm installation screws
