ARIETE Hot Aquapower 4240, Инструкция по эксплуатации

Страница: 17 / 38

IT
- 15 -
EN
• If you want to use the appliance as a wet and dry cleaner, with hot or cold water and with or without detergent, you need
to use the special “Magic Brush”
⑭
“and start the pump by pressing the relevant switch to dispense water (U) then use
the dial (P) to adjust the amount of detergent to use in the mix with water. Set the dial (P) to the 0 position to dispense
just water (
10
).
• To use hot water instead, after pressing the water dispensing switch (U), to start the pump, press the relevant switch (S) to start
up the heater and wait a few minutes.
• We recommend using a middle setting, according to the amount of detergent to be dispensed; it is possible to increase or
reduce the dose using the relevant dial.
• Dose the water or the mix of water and detergent dispensed by pressing the dispenser button
④
on the handgrip of the
suction hose
①
, then move the hose slowly over the surface to be cleaned to apply the detergent evenly. To dispense
in continuous mode when dealing with large surfaces, it is possible to lock the button
④
in a preset position by pressing
the lock key
⑤
.
• After dispensing the required amount of detergent and hot or cold water onto the surface, switch off the dispensing pump
by pressing the two switches (S-U), wait a few minutes for the detergent to act, start the suction function to remove the dirt
by pressing on/off button (N) as already illustrated and move the hose attachment in a backward direction.
• Dispense the detergent and move the hose slowly backwards across the surface being cleaned. The mix sprayed by the
appliance will be cleaned up immediately, along with any dirt.
• As soon as the blue “no water” light (O), èswitches on, it is necessary to fill the water container (X). as needed. To do this,
switch off the appliance, unplug it from the mains power and after removing the cap (V), refill the container.
• Also check the level of the detergent, using the gauge (K) and fill as required.
• If the suction power should diminish during use, this means that dirt needs to be removed from the container (G).
• After using the cleaner, switch off the appliance by pressing the suction on/off switch (N) and the water dispensing function
using the relevant switches (S-U).
• Unplug the appliance from the mains power and rewind the power cord automatically inside the appliance by pressing the
button (R) with your foot (
11
).
• The appliance can be stored using the special hook for the floor brush (
12
).
Soap adjustment
When the dial to adjust the amount of detergent is set to OFF, the appliance will only dispense hot or cold water, making it
possible to rinse the surfaces that have been washed.
As the dial is turned, the appliance will dispense increasing amounts of detergent.
ATTACHMENTS
Rigid suction tubes
⑬
Especially useful for reaching high or hidden areas (below furniture units, sofas, beds, etc.). These tubes can be fitted directly
to the hand grip
①
.
Floor brush
⑧
and parquet floor attachmenT
⑨
Ideal for cleaning hard surfaces such as floors or walls. A joint allows the brush to rotate through 360° to clean in all areas
that are difficult to reach. It can be fitted directly to the hand grip
①
or tube
⑬
. The parquet floor attachment
⑨
fits to the
brush
⑧
and is used for thorough parquet cleaning (
13
).
“Magic Brush”
⑭
liquid vacuum brush and rubber scraper
⑮
Ideal for cleaning up liquids on hard surfaces such as floors as well as on rugs and carpets. It guarantees perfect suction of
liquids to leave surfaces perfectly dry and it can be used for dry vacuum cleaning with excellent results.
Use it with the rubber scraper on hard surfaces and without the scraper on rugs and carpets (
14
).
To fit this attachment, push it in backwards or forwards so that the rubber scraper slides in easily.
When this attachment is used with the detergent dispenser, it is first necessary to fit the spray
⑥
to clean rugs and carpets
so as to apply detergent evenly over the surface to be cleaned. It can be fitted to the hand grip
①
or tube
⑬
.
WARNING: If the brush sticks to the floor during operation, it is sufficient to open the valve on the handgrip.
Crevice nozzle
⑦
Ideal for special cleaning operations (crevices between furniture units, seats and chairs or sofas) where suction cleaning is
difficult. It can be fitted to the hand grip
①
or tube
⑬
(
15
).