ARIETE 2712/1, Руководство пользователя

Страница: 37 / 90

- 35 -
EN
4) Linear cleaning:
by using the appropriate remote control buttons (8), the Robot may be controlled even when it is mov-
ing.
Important!
If manually directed towards different levels, the Robot may fall, as the manual control pre-
vails on the detecting sensor of empty spaces.
Important!
If manually directed, always consider that the detecting sensor of empty spaces (Z) is posi-
tioned on the rear part of the base.
5) Return to the Home base:
the Robot can be brought back to its base at any time through the remote control “ ” button or the
“HoME” button.
- the Robot must be able to intercept the IR signal from the charging station which must therefore be
in the same room as is being cleaned;
- if the Robot is not able to return to the base at the first attempt, it will continue to try until it is correctly
positioned.
Important!
If the Robot is unable to return to the charging station at its first attempt, it will continue to
try to do so until it is correctly positioned.
Important!
The Robot cannot return to the charging station if the station is not connected to the
mains power; in this case, the suction function will be reduced until it runs out and the
Robot will switch off.
Important!
During the return to the charging station, the suction function is suspended and there-
fore, the noise level will be lower.
Important!
While the Robot is moving, to select the operating mode of the remote control, previou-
sly enter “pause” through the “CLEAN” button and, subsequently proceed with the
selection of the required function.